Rear Door Window Motor: Service and Repair

POWER WINDOW MOTOR REMOVAL/INSTALLATION

1. Fully lower the rear door glass.

2. Disconnect the negative battery cable.

3. Remove the following parts:

Rear door

- Inner sail garnish (See. Inner Sail Garnish Removal/Installation)

- Rear door trim (See. Removal and Replacement)

- Rear door speaker (See. Rear Door Speaker Removal/Installation)

4. Remove the bolts.






5. Remove the power window motor from the power window regulator.

6. Disconnect the power window motor connector.

7. Install in the reverse order of removal.

NOTE:
- When installing the power window motor to the power window regulator drum, the drum housing tabs may detach from the door module. If this happens, insert a hand through the speaker installation hole to engage the drum housing tabs, and install the power window motor to the drum while supporting the drum housing.