Pinpoint Test 16: DTC B1318 (Front Display Interface Module [FDIM])

PINPOINT TEST 16: DTC B1318 (FRONT DISPLAY INTERFACE MODULE [FDIM])

Normal Operation

- DTC B1318 (Battery Voltage Low) - set by the front display interface module (FDIM) when the supply voltage falls below 10 volts for at least 10 seconds during normal operation.

Possible Causes
- Wiring, terminals or connectors
- High circuit resistance
- FDIM

Diagnostic Procedure

CAUTION:Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the connector.
NOTE:Failure to disconnect the battery when instructed will result in false resistance readings. See Battery Disconnect.

Step 1-Step 5:

Step 6: