Programming and Relearning

PERIMETER LIGHTING FEATURE PROGRAMMING

1. Turn the ignition switch from the OFF to the ON position.

NOTE:The following steps must be carried out within 30 seconds or the procedure will need to be repeated. If the procedure needs to be repeated, wait 30 seconds between programming sessions.
2. Press the unlock button on the door lock control switch 3 times.

3. Turn the ignition switch from the ON to the OFF position.

4. Press the unlock button on the door lock control switch 3 times.

5. Turn the ignition switch to the ON position. The horn chirps once to indicate that programming mode is entered.

6. Within 30 seconds of entering the programming mode, press the unlock button on the door lock control switch twice to enable/disable the perimeter lighting feature. The horn chirps once if the perimeter lighting is disabled or a chirp followed by a honk if the perimeter lighting is enabled.

NOTE:The unlock button must be pressed twice within 5 seconds.
7. Programming ends when the ignition switch state changes or times out after 2 minutes.