Operation CHARM: Car repair manuals for everyone.
Home >> Mazda >> 2009 >> Tribute 2WD L4-2.5L Hybrid >> Repair and Diagnosis >> Powertrain Management >> Relays and Modules - Powertrain Management >> Relays and Modules - Computers and Control Systems >> Engine Control Module >> Service and Repair

Engine Control Module: Service and Repair



-
POWERTRAIN CONTROL MODULE (PCM) REMOVAL/INSTALLATION - 2.5L










Removal

1. Retrieve the module configuration. Carry out the module configuration retrieval steps of the Programmable Module Installation procedure. See Programmable Module Installation (PMI).

NOTE:PCM installation DOES NOT require new keys or programming of keys, only a Parameter Reset of the Passive Anti-Theft System (PATS).
2. Detach the wiring harness retainer from the cowl stud bolt.

3. Disconnect the 3 PCM electrical connectors.

4. Remove the 2 bolts and the PCM.

5. Remove and inspect the PCM cowl seal, install new if damaged.

Installation

1. Install the PCM cowl seal.

2. Install the PCM and the 2 bolts.

- Tighten to 6 Nm {0.6 kgf-m, 53 in-lbf}.

3. Connect the 3 PCM electrical connectors.

4. Attach the wiring harness retainer to the cowl stud bolt.

- Tighten to 6 Nm {0.6 kgf-m, 53 in-lbf}.

5. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation procedure. See Programmable Module Installation (PMI).

6. Reprogram the passive anti-theft system (PATS). Carry out the Parameter Reset procedure. See Key Programming Using Two Programmed Keys.

7. Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.

pro multis · About Operation CHARM