Oil Seal Replacement - FS5A-EL

OIL SEAL REPLACEMENT [FS5A-EL]

1. Disconnect the negative battery cable.

2. Remove the aerodynamic under cover NO.2. Aerodynamic Under Cover No.2 Removal/Installation

3. Drain the ATF into a separate suitable container. Automatic Transaxle Fluid (ATF) Replacement - FS5A-EL

CAUTION:
- The oil seal is easily damaged by the sharp edges of the drive shaft splines. Do not let the splines contact the oil seal.

4. Remove the drive shaft and/or joint shaft. Drive Shaft Removal/Installation Joint Shaft Removal/Installation

5. Remove the oil seal using a flat-head screwdriver.

6. Using the SST and a hammer, tap a new oil seal in evenly until the SST contacts the transaxle case.






7. Coat the lip of the oil seal with ATF.

8. Install the drive shaft and/or joint shaft. Drive Shaft Removal/Installation Joint Shaft Removal/Installation

9. Add the ATF. Automatic Transaxle Fluid (ATF) Replacement - FS5A-EL

10. Install the aerodynamic under cover NO.2. Aerodynamic Under Cover No.2 Removal/Installation

11. Perform the "Mechanical System Test". Mechanical System Test - FS5A-EL