Input/Turbine Speed Sensor Removal/Installation - AW6A-EL

INPUT/TURBINE SPEED SENSOR REMOVAL/INSTALLATION [AW6A-EL]

WARNING:
- A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until then are cool.
- Using compressed air can cause dirt and other particles to fly out, causing injury to the eyes. Wear protective eyeglasses whenever using compressed air

CAUTION:
- If foreign materials are stuck to the sensor, disturbance by magnetic flux can cause sensor output to be abnormal and thereby negatively affect control. Make sure that foreign materials such as iron filings are not stuck to the sensor during installation.
- Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the connector when disconnecting it.

1. Remove the control valve body.
a. Disconnect the negative battery cable.

b. Remove the air cleaner component. Service and Repair

c. Remove the air cleaner bracket.

d. Remove the TCM. TCM Removal/Installation - AW6A-EL

e. Clean the transaxle exterior throughout with a steam cleaner or cleaning solvents.

f. Drain the ATF into a separate suitable container. Automatic Transaxle Fluid (ATF) Replacement - AW6A-EL

g. Disconnect the oil hose from the transaxle.

h. Remove the oil pipe. Oil Cooler Removal/Installation - AW6A-EL

i. Remove the control valve body cover.

j. Remove the control valve body. Control Valve Body Removal/Installation - AW6A-EL

2. Remove the input/turbine speed sensor.






3. Install the input/turbine speed sensor.

Tightening torque
- 3.9-6.9 Nm {40-70 kgf-cm, 35-61 in-lbf}

4. Install the control valve body. Control Valve Body Removal/Installation - AW6A-EL

5. Install the control valve body cover.

6. Install the oil pipe. Oil Cooler Removal/Installation - AW6A-EL

7. Connect the oil hose to the transaxle.

8. Add the ATF. Automatic Transaxle Fluid (ATF) Replacement - AW6A-EL

9. Install the TCM. TCM Removal/Installation - AW6A-EL

10. Install the air cleaner bracket.

11. Install the air cleaner component. Service and Repair

12. Connect the negative battery cable.