Overhaul

A/C UNIT DISASSEMBLY/ASSEMBLY

1. Disassemble in the order indicated in the table.

CAUTION:
- If a non-specified grease is used, it may result in abnormal noise or improper operation of the links. Apply only the specified grease to each link.

2. Assemble in the reverse order of disassembly.




X: Applicable-: Not applicable





Evaporator Temperature Sensor Assembly Note

1. Assemble the evaporator temperature sensor as shown in the figure.






CAUTION:
- When installing the evaporator temperature sensor without replacing the evaporator, assemble the evaporator temperature sensor with the installation position slid to the left of the previous position by 1 line. If the evaporator temperature sensor is assembled to the previously installed position, it may not function due to poor contact of the fin surface with the sensor detection area caused by fin deformation.

NOTE:
- Replace the evaporator in which the evaporator temperature sensor cannot be correctly positioned.

Adhesive Polyurethane (2) Assembly Note

1. Wrap the low-pressure side of the evaporator pipe with insulator. (With insulator)






2. Assemble the adhesive polyurethane as shown in the figure.