Secondary Gear and Output Gear Disassembly

SECONDARY GEAR AND OUTPUT GEAR DISASSEMBLY

Structural View






Disassembly Procedure

1. Perform the following inspection:

CAUTION:
- If there is no malfunction based on the results of the inspection, it not necessary to disassemble the secondary gear and output gear.
- Visual inspection of parts (See VISUAL INSPECTION OF PARTS)
- Secondary gear and output gear inspection (See SECONDARY GEAR AND OUTPUT GEAR INSPECTION)
- If there is a malfunction, disassemble the secondary gear and output gear and replace the malfunctioning part with a new part.







2. Using the SST and press, remove the secondary gear and the taper roller bearing (transaxle case side).

A : Press






A : Taper roller bearing (transaxle case side)
B : Secondary gear











3. Using the SSTs and press, remove the taper roller bearing (converter housing side).

A : Press

CAUTION: When removing the taper roller bearing, the cage will deform when the SST is put on the taper roller bearing cage. When assembling the secondary gear and output gear, use a new taper roller bearing.

4. Clean the disassembled parts. (See AUTOMATIC TRANSAXLE CLEANING.)