Oil Seal (Manual Shaft) Replacement

OIL SEAL (MANUAL SHAFT) REPLACEMENT [AW6A-EL, AW6AX-EL]

CAUTION:
- Water or foreign material entering the connector can cause a poor connection or corrosion. Be sure not to allow water or foreign material on the connector when disconnecting.

1. Disconnect the negative battery cable.

2. Remove the air cleaner component. Service and Repair

3. Remove the TCM. Service and Repair

CAUTION:
- Do not damage the transaxle case.
- Do not damage the manual shaft.

4. Remove and discard the oil seal using a tape-wrapped flathead screwdriver.






CAUTION:
- Do not damage the oil seal.

5. Using the SSTs and a hammer, tap a new oil seal so that the specified oil seal position is obtained.






Substitution SST
- 49 F026 102
Outer diameter: 27 mm {1.06 in} or more
Inner diameter: 15-18 mm {0.60-0.70 in}

6. Install the TCM. Service and Repair

7. Install the air cleaner component. Service and Repair

8. Connect the negative battery cable.

9. Perform the neutral position learning. Programming and Relearning