NEUTRAL SWITCH INSPECTION [WL-3]

id0140b5800800

Note
•  Perform the following inspection only when directed.

Continuity Inspection

1.  Disconnect the neutral switch connector.

2.  Inspect for continuity between the neutral switch terminals using an ohmmeter.

•  If not as specified, replace the neutral switch.
•  If as specified, carry out the "Circuit Open/Short Inspection".
dbg140awb331

Specification

Neutral switch

Shift lever

Continuity condition
Push the rod
In neutral
Continuity
Except above
Others
No continuity


Circuit Open/Short Inspection

1.  Disconnect the PCM connector. (See PCM REMOVAL/INSTALLATION [WL-3].)

2.  Inspect for an open or short circuit in the following wiring harnesses.

•  If there is an open or short circuit, repair or replace wiring harnesses.
dbg140awb330
dbg140awb305

Open circuit
•  Power circuit (neutral switch connector terminal B and PCM connector terminal 1D)
•  Ground circuit (neutral switch connector terminal A and body ground)
Short circuit
•  Neutral switch terminal B and PCM connector terminal 1D short to ground