DTC C1194, C1198, C1202, C1206, C1210, C1214
id040200876400
|
DTC
|
C 1194
C 1198
C 1202
C 1206
C 1210
C 1214
|
LF outlet solenoid valve system
LF inlet solenoid valve system
Rear outlet solenoid valve system
Rear inlet solenoid valve system
RF outlet solenoid valve system
RF inlet solenoid valve system
|
|
|
DETECTION CONDITION
|
• Solenoid valve operation does not correspond to solenoid ON/OFF commands from the ABS HU/CM.
|
||
|
POSSIBLE CAUSE
|
• Open or short circuit in the ABS HU/CM internal solenoid valves
• Solenoid valve malfunction
• Poor connection at connectors (female terminal)
|
||
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
VERIFY SOLENOID VALVE OPERATION
• Turn the ignition switch or engine switch off.
• Connect the M-MDS to the DLC-2.
• Turn the ignition switch or engine switch to the ON position (engine off).
• Access the active command mode for the solenoid valve using the M-MDS.
• Does the solenoid valve operate?
|
Yes
|
Go to the next step.
|
|
No
|
Replace the ABS HU/CM, then go to the next step.
|
||
|
2
|
VERIFY DTC TROUBLESHOOTING COMPLETED
• Clear the DTC from the memory.
(See ON-BOARD DIAGNOSIS.)
• Start the engine and drive the vehicle at 12 km/h {7.5 mph} or more.
• Gradually slow down and stop vehicle.
• Are the same DTCs present?
|
Yes
|
Repeat the inspection from Step 1.
If the malfunction recurs, replace the ABS HU/CM, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
3
|
VERIFY AFTER REPAIR PROCEDURE
• Are any other DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
(See ON-BOARD DIAGNOSIS.)
|
|
No
|
DTC troubleshooting completed.
|
||