1. Combination switch installation
The combination switch and SRS coil are integrated, and cannot be replaced individually.
Caution
- Because the combination switch is integrated with the SRS coil, do not remove it or rotate the combination switch.
1) Install the combination switch to the steering shaft.
Note
- Align the protrusion of the combination switch with the notch of the steering shaft to install.
- Remove the metal band clamp when installing a new combination switch.
Legend
- Combination switch
- Metal band
2) Connect the connector to the combination switch.
2. Steering cowl installation
1) Install the steering cowl to the steering shaft.
Tightening torque: 2.5 N・m { 0.25 kgf・m / 22.1 lb・in }
Legend
- Steering upper cowl
- Steering lower cowl
3. Steering wheel installation
1) Install the steering wheel to the steering shaft according to the alignment marks placed during removal.
Tightening torque: 35 N・m { 3.6 kgf・m / 26 lb・ft }
Caution
- The steering wheel should never be installed using a hammer or tool that causes shock.
The steering wheel is designed to absorb impact.