1. Steering lock installation
1) Align the lock bar of the steering lock with the steering shaft side mounting position to install.
Legend
- Lock bar
2) Install the steering lock to the steering shaft.
Caution
- Do not damage the ICU antenna coil portion.
- Tighten the shear bolt until the head of the bolt is twisted off.
Models without the passive entry and start system
Legend
- Steering lock
- Shear bolt
- ICU antenna coil portion
Models with the passive entry and start system
Legend
- Steering lock
- Shear bolt
2. Combination switch installation
1) Install the combination switch to the steering shaft.
Note
- Align the protrusion of the combination switch with the notch of the steering shaft to install.
Legend
- Combination switch
- Metal band
2) Connect the connector to the combination switch.
3. Steering cowl installation
1) Install the steering cowl to the steering shaft.
Tightening torque: 2.5 N・m { 0.25 kgf・m / 22.1 lb・in }
Legend
- Steering upper cowl
- Steering lower cowl
4. Steering wheel installation
1) Install the steering wheel to the steering shaft according to the alignment marks placed during removal.
Tightening torque: 35 N・m { 3.6 kgf・m / 26 lb・ft }
Caution
- The steering wheel should never be installed using a hammer or tool that causes shock.
The steering wheel is designed to absorb impact.