1. Component views
Regular cab
Part name
- Front airbag sensor
- SRS control unit
- Floor side airbag sensor (Models with side airbags)
- Door side airbag sensor (Models with side airbags)
Crew cab
Part name
- Front airbag sensor
- SRS control unit
- Floor side airbag sensor (Models with side airbags)
- Door side airbag sensor (Models with side airbags)
- Rear side airbag sensor (Models with side airbags)
Extend cab
Part name
- Front airbag sensor
- SRS control unit
- Floor side airbag sensor (Models with side airbags)
- Door side airbag sensor (Models with side airbags)
- Rear side airbag sensor (Models with side airbags)
2. SRS airbag preparation
1. SRS deactivation
1) Set the ignition switch to LOCK and remove the key.
Note
- For models with the passive entry and start system, turn the power mode OFF.
2) Remove the SRS fuse from the fuse relay box.
3) Disconnect the battery cable from the battery negative terminal.
Caution
- After turning OFF the ignition switch (power mode for models with passive entry and start system), do not disconnect the battery cable within 3 minutes.
- If the battery cable is disconnected within 3 minutes, the vehicle electronic control system may malfunction.
- If the battery cable is disconnected, perform the setting of the front door power window switch with AUTO UP/AUTO DOWN function after connecting the battery negative terminal.
- After disconnecting the battery cable, do not perform work for approximately 15 seconds.
3. Driver seat removal
4. Passenger seat removal
5. Front sill plate removal
1) Remove the front sill plate from the floor.
Regular cab, crew cab
Legend
- Front sill plate
- Clip
- Claw section
Extend cab
Legend
- Front sill plate
- Clip
- Claw section
6. Floor side airbag sensor removal
1) Remove the protector from the floor panel.
2) Disconnect the connector from the floor side airbag sensor.
3) Remove the floor side airbag sensor from the floor panel.
Legend
- Floor carpet
- Protector
- Floor side airbag sensor