1. Component views
Regular cab
Part name
- Front airbag sensor
- SRS control unit
- Floor side airbag sensor (Models with side airbags)
- Door side airbag sensor (Models with side airbags)
Crew cab
Part name
- Front airbag sensor
- SRS control unit
- Floor side airbag sensor (Models with side airbags)
- Door side airbag sensor (Models with side airbags)
- Rear side airbag sensor (Models with side airbags)
Extend cab
Part name
- Front airbag sensor
- SRS control unit
- Floor side airbag sensor (Models with side airbags)
- Door side airbag sensor (Models with side airbags)
- Rear side airbag sensor (Models with side airbags)
2. Floor side airbag sensor installation
1) Install the floor side airbag sensor to the floor panel.
Tightening torque: 8.0 N・m { 0.8 kgf・m / 71 lb・in }
2) Connect the connector to the floor side airbag sensor.
3) Install the protector to the floor panel.
Tightening torque: 8.0 N・m { 0.8 kgf・m / 71 lb・in }
Legend
- Floor carpet
- Protector
- Floor side airbag sensor
3. Front sill plate installation
1) Install the front sill plate to the floor.
Regular cab, crew cab
Legend
- Front sill plate
- Clip
- Claw section
Extend cab
Legend
- Front sill plate
- Clip
- Claw section
4. Passenger seat installation
5. Driver seat installation
6. SRS airbag setting
1. SRS reactivation
Warning
- Never use SRS parts from other vehicles or models.
- Make sure to check the part numbers and use the SRS components intended for the target vehicle.
1) Set the ignition switch to LOCK and remove the key.
Note
- For models with the passive entry and start system, turn the power mode OFF.
2) Make sure that the connectors of the SRS components (SRS airbag, SRS control unit, seat belt with pretensioner, SRS coil, etc.) are fully connected.
3) Install the SRS fuse to the fuse relay box, and connect the battery cable to the negative terminal of the battery.
4) Turn ON the ignition switch and verify that the SRS airbag warning light turns OFF after illuminating for 6 seconds.
Caution
- If the SRS airbag warning light does not operate properly, perform Diagnostic system check - SRS controls.
5) Referring to the following, perform the setting of the front door power window switch with AUTO UP/AUTO DOWN function.
Refer to "9.Body, Cab, Accessories 9T.Glass, Windows, Mirrors front door power window switch setting".