1. Lubricating system inspection
1. Oil pressure inspection
1) Inspect whether the engine oil is dirty or contains water.
Note
- If the oil is dirty or contains water, change the oil after investigating the causes and taking appropriate measures.
2) Inspect the engine oil level.
Note
- When the oil level is low, replenish it.
3) Remove the oil pressure switch.
Refer to "1.Engine 1E.Lubrication(4JJ3 with DPD) oil pressure switch removal".
Legend
- Oil pressure switch
4) Install the oil pressure gauge.
5) Warm up the engine.
6) Measure to inspect whether the oil pressure is the specified value.
Standard: 400 kPa { 4.1 kgf/cm2 / 58 psi } / 3600 rpm
7) Turn OFF the ignition switch.
8) Remove the oil pressure gauge.
9) Install the oil pressure switch.
Refer to "1.Engine 1E.Lubrication(4JJ3 with DPD) oil pressure switch installation".
10) After starting the engine, check for oil leakage.