TCCM removal

1. Preliminary and post procedures

1. Preliminary procedures

1) Open the engine hood.

2) Disconnect the battery cable from the battery negative terminal.

Caution

  • After turning OFF the ignition switch (power mode for models with passive entry and start system), do not disconnect the battery cable within 3 minutes.
  • If the battery cable is disconnected within 3 minutes, the vehicle electronic control system may malfunction.
  • If the battery cable is disconnected, perform the setting of the front door power window switch with AUTO UP/AUTO DOWN function after connecting the battery negative terminal.

2. Glove box removal

1) Remove the glove box from the instrument panel.

RHD

Legend

  1. Glove box

LHD

Legend

  1. Glove box

3. Instrument panel passenger-side lower cover removal

1) Remove the instrument panel passenger-side lower cover from the instrument panel.

RHD

Legend

  1. Instrument panel passenger-side lower cover
  2. Clip

LHD

Legend

  1. Instrument panel passenger-side lower cover
  2. Clip

2) Disconnect the connector from the instrument panel passenger-side lower cover.

4. ECM removal

Refer to "1.Engine 1Z.Engine Electrical Control(4JJ3 with DPD) ECM removal".

Refer to "1.Engine 1Z.Engine Electrical Control(4JJ3 without DPD) ECM removal".

Refer to "1.Engine 1Z.Engine Electrical Control(RZ4E-TC) ECM removal".

5. TCCM removal

1) Disconnect the connector from the TCCM.

2) Remove the TCCM from the reinforcement.

RHD

LHD

Copyright Mazda Motor Corporation. All rights reserved.