Refer to "51.Engine Control 1A.Troubleshooting(4JJ3 with DPD) Diagnostic system check-engine controls".
1) Connect the scan tool.
2) Turn OFF the ignition switch for 1 minute or more.
3) Turn ON the ignition switch.
4) Observe the DTC information with a scan tool. Is a DTC set?
Yes
No
Note
Refer to "1.Engine 1Z.Engine Electrical Control(4JJ3 with DPD) ECM removal".
Refer to "1.Engine 1Z.Engine Electrical Control(4JJ3 with DPD) ECM installation".
Refer to "1.Engine 1Z.Engine Electrical Control(4JJ3 with DPD) ECM setting".
Procedure completion
1) Clear the DTC with a scan tool.
2) Turn OFF the ignition switch for 1 minute or more.
3) Turn ON the ignition switch.
4) Observe the DTC information with a scan tool.