DTC P0565 Cruise Control On Signal (4JJ3 with DPD)

For the diagnostic type, refer to the diagnostic type list in the DTC description.

1. Engine control system check

Refer to "51.Engine Control 1A.Troubleshooting(4JJ3 with DPD) Diagnostic system check-engine controls".

2. Current DTC check

1) Connect the scan tool.

2) Turn OFF the ignition switch for 1 minute or more.

3) Turn ON the ignition switch.

4) Observe the DTC information with a scan tool. Is a DTC set?

Yes

=>Go to Cruise control main switch operation signal input check.

No

Go to Intermittent conditions of engine.

Refer to "202.Engine 15D.Symptom(4JJ3 with DPD) intermittent conditions of engine".

3. Cruise control main switch operation signal input check

1) Turn OFF the ignition switch.

2) Disconnect the cruise control steering wheel switch harness connector (B34).

3) Turn ON the ignition switch.

4) Observe the Cruise Main Switch parameter on the scan tool. Does the Cruise Main Switch parameter display OFF?

Yes

Replace the cruise control steering wheel switch.

Refer to "9.Body, Cab, Accessories 9C.Electrical Control, Entertainment cruise control steering wheel switch removal".

Refer to "9.Body, Cab, Accessories 9C.Electrical Control, Entertainment cruise control steering wheel switch installation".

=>Go to Repair verification.

No

=>Go to Inspection for short to power supply in cruise control main switch signal circuit.

4. Inspection for short to power supply in cruise control main switch signal circuit

1) Inspect the cruise control main switch signal circuit between the ECM (pin 9 of C8) and the cruise control steering wheel switch (pin 10 of B34) for a short to the battery power supply circuit or a short to the ignition power supply circuit. Is the result normal?

Yes

=>Go to ECM replacement.

No

Repair the circuit as necessary.

=>Go to Repair verification.

5. ECM replacement

Refer to "1.Engine 1Z.Engine Electrical Control(4JJ3 with DPD) ECM removal".

Refer to "1.Engine 1Z.Engine Electrical Control(4JJ3 with DPD) ECM installation".

Refer to "1.Engine 1Z.Engine Electrical Control(4JJ3 with DPD) ECM setting".

Procedure completion

=>Go to Repair verification.

6. Repair verification

1) Clear the DTC with a scan tool.

2) Turn OFF the ignition switch for 1 minute or more.

3) Turn ON the ignition switch.

4) Operate the switch while observing the Cruise Main Switch parameter on the scan tool. Is ON displayed when the switch is operated and OFF when it is released?

Yes

Observe the DTC information with a scan tool.

No

=>Go to Cruise control main switch operation signal input check.