DTC P0567 Cruise Control Resume Signal (4JJ3 without DPD)

1. DTC P0567 description

The cruise control maintains the vehicle speed at a speed set by a driver. When the cruise control main switch is turned ON, a signal is sent to the ECM, and the cruise control indicator light in the instrument panel cluster illuminates. When the cruise control cancel switch is applied, the cruise control system is disabled. When the cruise control resume switch is applied, a switch signal is sent to the ECM, and the vehicle speed is reset to the previous set speed or the vehicle speed increases. If the ECM detects that the cruise control resume switch signal repeats ON and OFF or stays ON, the DTC is set.

Diagnostic type list
Diagnostics (Type 1)	Models with stereo cameras
Diagnostics (Type 2)	Models without stereo cameras

2. Condition for setting DTC P0567

Condition for running the DTC

The battery voltage is 9 to 16 V.
The ignition switch is ON.
The engine is running.

Condition for setting the DTC

Any of the following are met:

The ECM detects that the cruise control resume switch signal continuously repeats ON and OFF within a very short adjustment time.
The ECM detects that the cruise control resume switch signal stays at the ON position (low voltage) for 120 seconds or more.

3. Action taken when DTC P0567 sets

Euro4: The ECM illuminates the SVS indicator light. Refer to Action taken when DTC sets - Type C (Euro4).
Except Euro4: The ECM illuminates the check engine warning light. Refer to Action taken when DTC sets - Type A (Except Euro4).

Refer to "51.Engine Control 1A.Troubleshooting(4JJ3 without DPD) DTC type definitions".

The ECM inhibits the cruise control.

4. Condition for clearing DTC P0567

Euro4: Refer to Condition for clearing the SVS indicator light/DTC - Type C (Euro4).
Except Euro4: Refer to Condition for clearing the check engine warning light/DTC - Type A or Type B (Except Euro4).

Refer to "51.Engine Control 1A.Troubleshooting(4JJ3 without DPD) DTC type definitions".