1. DTC P1613 description
The solenoid cut terminal is built into the TCM. The TCM cuts the command current to each solenoid via signals from the main and sub-CPU. When the ignition switch is turned OFF, the TCM performs the solenoid cut request test.
2. Condition for setting DTC P1613
Condition for running the DTC
- The ignition switch is turned from ON to OFF.
Condition for setting the DTC
- The TCM detects a malfunction in both main solenoid cut terminal and sub solenoid cut terminal.
3. Action taken when DTC P1613 sets
- The TCM flashes the check trans warning light. Refer to Action taken when DTC sets - Type A.
Refer to "55.Transmission Control 5A.Troubleshooting(AWR6B45) DTC type definitions".
- The TCM inhibits the shift timing control.
- The TCM inhibits the lock-up timing control.
- The TCM inhibits the slip lock-up control.
- The TCM inhibits the garage control.
- The TCM inhibits the self-learning control.
- The TCM inhibits the engine torque control.
- The TCM inhibits the skip gear shift control.
- All the solenoids are turned OFF.
- If the DTC is set in the reverse gear, the gear is shifted to neutral.
- If the DTC is set in the D range, the gear is fixed to 5th.
4. Condition for clearing DTC P1613
- Refer to Condition for clearing the MIL, check trans warning light/DTC - Type A or Type B.
Refer to "55.Transmission Control 5A.Troubleshooting(AWR6B45) DTC type definitions".