1. DTC P0641 description
The ECM supplies 5 V power to the following sensors via 5 V reference circuit 1.
- Accelerator pedal position sensor 1
The ECM supplies 5 V power to the following sensors via 5 V reference circuit 7.
5 V reference circuit 1 and 7 are independent of each other outside the ECM but share the bus inside the ECM. Therefore, whole 5 V reference circuits 1 and 7 may be affected by a short circuit in one of the sensor 5 V reference circuits. The ECM monitors the voltage of 5 V reference circuits 1 and 7, and if it detects that the voltage is excessively low or high, the DTC is set.
2. Condition for setting DTC P0641
Condition for running the DTC
- The battery voltage is 9 to 16 V.
- The ignition switch is ON.
- DTC P060B is not set.
Refer to "51.Engine Control 1A.Troubleshooting(4JJ3 without DPD) DTC P060B Internal Control Module A/D Processing Performance".
Condition for setting the DTC
- The ECM detects that the voltage of 5 V reference circuit 1 or 7 is 4.5 V or less, or 5.5 V or more.
3. Action taken when DTC P0641 sets
- Euro4: The ECM illuminates the MIL. Refer to Action taken when DTC sets - Type A (Euro4).
- Except Euro4: The ECM illuminates the check engine warning light. Refer to Action taken when DTC sets - Type A (Except Euro4).
Refer to "51.Engine Control 1A.Troubleshooting(4JJ3 without DPD) DTC type definitions".
- The ECM inhibits the cruise control.
4. Condition for clearing DTC P0641
- Euro4: Refer to Condition for clearing the MIL/DTC - Type A or Type B (Euro4).
- Except Euro4: Refer to Condition for clearing the check engine warning light/DTC - Type A or Type B (Except Euro4).
Refer to "51.Engine Control 1A.Troubleshooting(4JJ3 without DPD) DTC type definitions".