DTC P0560 System Voltage (4JJ3 without DPD)

1. DTC P0560 description

The ECM supplies 12 V power to the MAF sensor. The ECM monitors the voltage of the 12 V reference circuit. If the ECM detects an excessively low or high voltage, the DTC is set.

2. Condition for setting DTC P0560

Condition for running the DTC

  • The battery voltage is 9 to 16 V.
  • DTC P060B is not set.

Refer to "51.Engine Control 1A.Troubleshooting(4JJ3 without DPD) DTC P060B Internal Control Module A/D Processing Performance".

Condition for setting the DTC

  • The ECM detects that the voltage of the 12 V reference circuit is 7 V or less, or 16 V or more.

3. Action taken when DTC P0560 sets

  • Euro4: The ECM illuminates the MIL. Refer to Action taken when DTC sets - Type A (Euro4).
  • Except Euro4: The ECM illuminates the check engine warning light. Refer to Action taken when DTC sets - Type A (Except Euro4).

Refer to "51.Engine Control 1A.Troubleshooting(4JJ3 without DPD) DTC type definitions".

  • The ECM limits the fuel injection quantity.
  • The ECM inhibits the cruise control.

4. Condition for clearing DTC P0560

  • Euro4: Refer to Condition for clearing the MIL/DTC - Type A or Type B (Euro4).
  • Except Euro4: Refer to Condition for clearing the check engine warning light/DTC - Type A or Type B (Except Euro4).

Refer to "51.Engine Control 1A.Troubleshooting(4JJ3 without DPD) DTC type definitions".

Copyright Mazda Motor Corporation. All rights reserved.