Refer to "64.Body Control 10I.Troubleshooting(eCall unit) diagnostic system check - emergency call system controls".
1) Connect the scan tool.
2) Turn ON the ignition switch.
3) Observe the DTC information with a scan tool. Is a DTC set?
Yes
=>Go to Antenna circuit inspection.
No
Go to Intermittent conditions of body control system.
Refer to "223.Body Control 36D.Symptom(eCall unit) intermittent conditions of body control system".
1) Inspect the antenna circuit between the eCall unit and the antenna for the following. Is the result normal?
Inspection items
Refer to "LHD eCall" in the ETM (wiring diagram). (Open using the ETM viewer.).
2) Are all of the results normal?
Yes
Replace the antenna.
Refer to "9.Body, Cab, Accessories 9E.Instrumentation, Driver Info. antenna removal".
Refer to "9.Body, Cab, Accessories 9E.Instrumentation, Driver Info. antenna installation".
=>Go to Current DTC follow-up check.
No
Repair the circuit as necessary.
1) Clear the DTC with a scan tool.
2) Turn OFF the ignition switch for 30 seconds or more.
3) Turn ON the ignition switch.
4) Observe the DTC information with a scan tool. Is a DTC set?
Yes
=>Go to eCall unit replacement.
No
Note
Refer to "9.Body, Cab, Accessories 9Z.Body, Cab, Accessories Electrical Control eCall unit removal".
Refer to "9.Body, Cab, Accessories 9Z.Body, Cab, Accessories Electrical Control eCall unit installation".
Refer to "9.Body, Cab, Accessories 9Z.Body, Cab, Accessories Electrical Control eCall unit setting".
Procedure completion
1) Clear the DTC with a scan tool.
2) Turn OFF the ignition switch for 30 seconds or more.
3) Turn ON the ignition switch.
4) Observe the DTC information with a scan tool.