1. DTC P0662 description
The ECM controls an excessive flow rate by energizing the swirl control solenoid valve based on the vehicle running condition. The ECM instructs the swirl control solenoid valve, applies vacuum pressure to the diaphragm actuator, and operates the swirl control butterfly installed to each intake port. If the ECM detects a short circuit in the solenoid valve circuit, the DTC is set.
2. Condition for setting DTC P0662
Condition for running the DTC
- The battery voltage is 9 to 16 V.
- The ignition switch is ON.
- Swirl control valve is commanded ON.
- DTC P1606 is not set.
Refer to "51.Engine Control 1A.Troubleshooting(4JJ3 without DPD) DTC P1606 ECM Internal IC Failure".
Condition for setting the DTC
- The ECM detects a high voltage condition in the swirl control solenoid valve circuit when the solenoid is commanded ON.
3. Action taken when DTC P0662 sets
- Euro4: The ECM illuminates the SVS indicator light. Refer to Action taken when DTC sets - Type C (Euro4).
- Except Euro4: The ECM illuminates the check engine warning light. Refer to Action taken when DTC sets - Type A (Except Euro4).
Refer to "51.Engine Control 1A.Troubleshooting(4JJ3 without DPD) DTC type definitions".
4. Condition for clearing DTC P0662
- Euro4: Refer to Condition for clearing the SVS indicator light/DTC - Type C (Euro4).
- Except Euro4: Refer to Condition for clearing the check engine warning light/DTC - Type A or Type B (Except Euro4).
Refer to "51.Engine Control 1A.Troubleshooting(4JJ3 without DPD) DTC type definitions".