Check 4WD warning light always on (4WD models)

1. Transfer control system check

Refer to "53.Driveline Control 3A.Troubleshooting(4WD models) diagnostic system check-transfer case controls".

2. Prioritized DTC check

1) Connect the scan tool.

2) Turn OFF the ignition switch for 30 seconds or more.

3) Start the engine.

4) Observe the DTC information with a scan tool. Is a DTC set?

Yes

Go to the applicable DTC diagnosis.

No

Replace the instrument panel cluster.

Refer to "9.Body, Cab, Accessories 9E.Instrumentation, Driver Info. instrument panel cluster removal".

Refer to "9.Body, Cab, Accessories 9E.Instrumentation, Driver Info. instrument panel cluster installation".

Refer to "9.Body, Cab, Accessories 9E.Instrumentation, Driver Info. instrument panel cluster setting".

=>Go to Repair verification.

3. Repair verification

1) Turn OFF the ignition switch for 30 seconds or more.

2) Turn ON the ignition switch.

3) Check whether the check 4WD warning light turns OFF after illuminating for approximately 3 seconds.