CAR-NAVIGATION SYSTEM DOES NOT START OPERATION [CAR-NAVIGATION SYSTEM]


id0903e8100000

Possible DTC

Even if the NAVI mode is selected, the car-navigation system screen does not display.

POSSIBLE CAUSE
•  NAVI switch malfunction
•  Power supply fuse (+B, ACC) burnt out
•  Open or short circuit in power supply (+B, ACC, GND) wiring harness
•  Open or short circuit in power supply (+B, ACC, GND) wiring harness
•  Open or short circuit in wiring harness between audio unit and car-navigation unit communication system
•  Car-navigation unit malfunction
•  Audio unit malfunction


Diagnostic Procedure

Step

Inspection

Action

1
VERIFY MALFUNCTION SYMPTOM
•  Switch the ignition ON (engine off or on).
•  Turn the audio unit power supply on and select the NAVI mode.
•  Does the car-navigation system launch and the map screen display?
Yes
Go to Step 6.
No
Go to the next step.
2
DETERMINE IF MALFUNCTION CAUSE IS SWITCH
•  Operate switches other than the NAVI switch.
•  Do the modes other than the NAVI mode switch normally?
Yes
Go to the next step.
No
Inspect the switch referring to the switch inspection procedure of the diagnostic assist function.
3
INSPECT CAR-NAVIGATION UNIT POWER SUPPLY
•  Switch the ignition to ACC.
•  Measure the voltage at the following terminals:
―  Terminal 1H (+B)
―  Terminal 1G (ACC)
•  Is the voltage value the battery voltage?
Yes
Go to the next step.
No
•  Inspect the AUDIO1 15 A or AUDIO2 7.5 A fuse.
If the fuse is burned out:
•  Inspect for a short to ground in the wiring harness between the AUDIO1 15A fuse and car- navigation unit terminal 1H, or the AUDIO2 7.5 A fuse and car-navigation unit terminal 1G, and perform repairs.
If the fuse is not damaged or burned out:
•  Inspect for an open circuit in the wiring harness between the battery and car-navigation unit terminal 1H or 1G.
4
INSPECT CAR-NAVIGATION UNIT GROUND
•  Switch the ignition off (LOCK).
•  Disconnect the audio unit connector.
•  Verify the continuity between ground and the following terminal connectors 1A, 1B, 1C, and 1D on the wiring harness side.
•  Is there continuity?
Yes
Go to the next step.
No
Inspect and repair the ground point for looseness, disengagement, or lifting. Inspect and repair the wiring harness for an open circuit.
5
INSPECT CAR-NAVIGATION UNIT COMMUNICATION
•  Switch the ignition off (LOCK).
•  Disconnect the audio unit connector.
•  Inspect for malfunction between the following wiring harnesses.
―  Audio unit terminal 5A and car-navigation unit terminal 2A
―  Audio unit terminal 5B and car-navigation unit terminal 2B
―  Audio unit terminal 5C and car-navigation unit terminal 2C
―  Audio unit terminal 5D and car-navigation unit terminal 2D
•  Is any malfunction verified?
Yes
Inspect and repair the wiring harness.
No
Go to the next step.
6
DETERMINE IF MALFUNCTION CAUSE IS car-navigation UNIT
•  Switch the ignition ON (engine off or on).
•  Launch the audio unit diagnostic assist function.
•  Select diagnostic assist code 16 external device connection information clearing.
•  Switch the ignition off (LOCK).
•  Switch the ignition ON (engine off or on).
•  Launch the audio unit diagnostic assist function.
•  Select diagnostic assist code 15 vehicle NAVI signal verification.
•  Is NAVI (USB) NG displayed?
Yes
Replace the car-navigation unit.
No
Replace the audio unit.