DISCHARGE HEADLIGHT SYSTEM INSPECTION


id091800805400

Warning
•  Incorrect servicing of the discharge headlights could result in electrical shock. Before servicing the discharge headlights, always refer to the service warnings. (See DISCHARGE HEADLIGHT SERVICE WARNINGS.)

Terminal layout

ac5wzw00000460

Inspection procedure

Step

Inspection

Action

1
INSPECT RELAY
•  Remove the following relays:
―  Headlight LO relay (LH)
―  Headlight LO relay (RH)
•  Inspect the relays.
•  Are the relays normal?
Yes
Install the relays, then go to the next step.
No
Replace the relay.
2
INSPECT LIGHT SWITCH
•  Inspect the light switch.
•  Is the light switch normal?
Yes
Go to the next step.
No
Replace the light switch.
3
INSPECT DISCHARGE HEADLIGHT CONTROL MODULE CONNECTOR
•  Disconnect the discharge headlight control module connector.
•  Inspect the connector connection, connection condition or the terminal and verify that there is no damage, deformation, corrosion, or disconnection.
•  Is the connector normal?
Yes
Go to the next step.
No
Repair or replace the connector.
4
INSPECT DISCHARGE HEADLIGHT CONTROL MODULE FOR OPEN CIRCUIT TO GROUND CIRCUIT
•  Verify that the discharge headlight control module is disconnected.
•  Inspect the wiring harness between discharge headlight control module B (wiring harness-side) and ground.
•  Is there continuity?
Yes
Go to the next step.
No
Repair or replace the wiring harness for an open circuit.
5
INSPECT DISCHARGE HEADLIGHT CONTROL MODULE POWER SUPPLY CIRCUIT
•  Verify that the discharge headlight control module connector is disconnected.
•  Turn the light switch to the HEAD position.
•  Measure the voltage at discharge headlight control module terminal A (wiring harness-side).
•  Is the voltage B+?
Yes
Turn the light switch to the OFF position, then go to the next step.
No
Inspect the HID L 15 A fuse and HID R 15 A fuse.
•  If a fuse is burnt out:
―  Repair or replace the wiring harness for a short to ground.
―  Replace the fuse.
•  If a fuse is burnt out:
―  Replace the fuse.
•  If the fuse is normal:
―  Repair or replace the wiring harness for an open circuit.
6
VERIFY IF HEADLIGHT HI/LO BULB IS BAD OR DISCHARGE HEADLIGHT CONTROL MODULE IS MALFUNCTIONING
•  Install a normal headlight HI/LO bulb.
•  Make sure to reconnect the disconnected connectors.
•  Turn the light switch to the HEAD position.
•  Do the headlights LO illuminate?
Yes
Replace the headlight HI/LO bulb.
No
Replace the discharge headlight control module.