DTC P034B:00 [PCM (SKYACTIV-D 2.2)]


id0102j5218400

DTC P034B:00

CKP sensor circuit range/performance problem

DETECTION CONDITION
•  With the following conditions met, the reverse rotation pulse is detected while the crankshaft is rotated clockwise.
―  Battery voltage: 8―16 V
―  The following DTCs are not detected
•  CKP sensor: P0336:00, P0337:00
•  Constant voltage power supply control system: P0642:00, P0643:00
Diagnostic support note
•  This is a continuous monitor (other).
•  The check engine light does not illuminate.
•  FREEZE FRAME DATA/Snapshot data is available.
•  DTC is stored in the PCM memory.
FAIL-SAFE FUNCTION
•  Inhibits engine-stop by i-stop control.
POSSIBLE CAUSE
•  CKP sensor malfunction
•  PCM malfunction
SYSTEM WIRING DIAGRAM
Not applicable


Diagnostic Procedure

Step

Inspection

Results

Action

1
VERIFY OTHER RELATED DTCs
•  Switch the ignition OFF, and then switch it ON (engine off).
•  Display the DTCs using the M-MDS.
•  Has any DTC other than P034B:00 been stored?
Yes
Repair the malfunctioning location according to the applicable DTC troubleshooting.
No
Go to the next step.
2
INSPECT CKP SENSOR
•  Is the CKP sensor normal?
Yes
Go to the next step.
No
Replace the CKP sensor, then go to the next step.
3
VERIFY THAT REPAIRS HAVE BEEN COMPLETED
•  Reconnect all the disconnected connectors.
•  Refer to the [MEMORY CLEARING PROCEDURE] and clear the DTC.
•  After driving the vehicle and operating i-stop, restart the engine.
•  Stop the engine.
•  Display the DTCs using the M-MDS.
•  Has DTC P034B:00 been recorded?
Yes
Repeat the inspection from Step 1.
•  If the malfunction recurs, replace the PCM, then go to the next step.
No
Go to the next step.
4
VERIFY OTHER DTCs
•  Has any other DTC or pending code been stored?
Yes
Repair the malfunctioning location according to the applicable DTC troubleshooting.
No
DTC troubleshooting completed.