DTC B00A0:55 [SAS CONTROL MODULE (TWO-STEP DEPLOYMENT CONTROL SYSTEM)]

id0802g8007600

System malfunction location	•  Configuration setting error (occupant classification sensor structural malfunction)
Detection condition	Warning •  Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection according to only the detection conditions may cause injury due to an operating error, or damage the system. When performing an inspection, always follow the inspection procedure. •  SAS control module configuration setting has not been done correctly •  Parts which have not been set to SAS control module are assembled
Fail-safe function	Not applicable
Possible cause	•  SAS control module configuration setting not implemented •  SAS control module configuration setting invalid •  Occupant classification sensor assembly incorrect •  SAS control module malfunction
System wiring diagram	Not applicable

Diagnostic Procedure

Step	Inspection		Action
1	PERFORM SAS CONTROL MODULE CONFIGURATION (AS-BUILT DATA USE) •  Perform the SAS control module configuration using the M-MDS. (See SAS CONTROL MODULE CONFIGURATION (USING AS-BUILT DATA) [TWO-STEP DEPLOYMENT CONTROL SYSTEM].) •  Clear the DTC for the SAS control module using the M-MDS. (See CLEARING DTC [SAS CONTROL MODULE (TWO-STEP DEPLOYMENT CONTROL SYSTEM)].) •  Perform the DTC inspection for the SAS control module using the M-MDS. (See DTC INSPECTION [SAS CONTROL MODULE (TWO-STEP DEPLOYMENT CONTROL SYSTEM)].) •  Is the same DTC present?	Yes	Go to the next step.
		No	DTC troubleshooting completed.
2	INSPECT OCCUPANT CLASSIFICATION SENSOR INSTALLATION CONDITION •  Verify that the occupant classification sensor is correctly installed. (See FRONT SEAT CUSHION TRIM REMOVAL/INSTALLATION.) •  Is the occupant classification sensor correctly installed?	Yes	Go to the next step.
		No	Correctly Install the occupant classification sensor. (See FRONT SEAT CUSHION TRIM REMOVAL/INSTALLATION.) Then go to the next step.
3	PERFORM SAS CONTROL MODULE DTC INSPECTION •  Clear the DTC for the SAS control module using the M-MDS. (See CLEARING DTC [SAS CONTROL MODULE (TWO-STEP DEPLOYMENT CONTROL SYSTEM)].) •  Perform the DTC inspection for the SAS control module using the M-MDS. (See DTC INSPECTION [SAS CONTROL MODULE (TWO-STEP DEPLOYMENT CONTROL SYSTEM)].) •  Is the same DTC present?	Yes	Replace the SAS control module. (See SAS CONTROL MODULE REMOVAL/INSTALLATION [TWO-STEP DEPLOYMENT CONTROL SYSTEM].)
		No	DTC troubleshooting completed.