TRANSAXLE FLUID TEMPERATURE (TFT) SENSOR REMOVAL/INSTALLATION [AW6A-EL, AW6AX-EL]

id051723801100

Warning

•  A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool before replacing the ATF.

Caution

•  Water or foreign material entering the connector can cause a poor connection or corrosion. Be sure not to allow water or foreign material on the connector when disconnecting.

•  Do not damage the terminals.

1.  Disconnect the negative battery cable.

2.  Remove the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [L3 Turbo].)

3.  Remove the under cover.

4.  Drain the ATF. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT [AW6A-EL, AW6AX-EL].)

5.  Remove the TCM. (See TCM REMOVAL/INSTALLATION [AW6A-EL, AW6AX-EL].)

6.  Remove the resonance chamber. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [L3 Turbo].)

7.  Remove the thermo valve. (See OIL COOLER REMOVAL/INSTALLATION [AW6A-EL, AW6AX-EL].)

acxaaw00000177

8.  Remove the control valve body. (See CONTROL VALVE BODY REMOVAL/INSTALLATION [AW6A-EL, AW6AX-EL].)

9.  Remove the coupler component lock plate.

acxaaw00000178

Caution

•  Do not damage the wiring harness.

•  Do not pull hard on the wiring harness.

10.  Remove the coupler component from the transaxle case.

11.  Remove the O-ring and the gasket from the coupler component.

acxaaw00000179

12.  Apply ATF to a new gasket and install it on the coupler component.

Caution

•  Do not apply ATF to the O-ring.

13.  Install a new O-ring to the coupler component.

acxaaw00000179

Caution

•  Do not apply too much force to the coupler component.

•  Do not damage the coupler component.

14.  Install the coupler component to the transaxle case.

15.  Install a new coupler component lock plate.

acxaaw00000180

16.  Install the control valve body. (See CONTROL VALVE BODY REMOVAL/INSTALLATION [AW6A-EL, AW6AX-EL].)

17.  Install the thermo valve. (See OIL COOLER REMOVAL/INSTALLATION [AW6A-EL, AW6AX-EL].)

18.  Install the resonance chamber. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [L3 Turbo].)

19.  Install the TCM. (See TCM REMOVAL/INSTALLATION [AW6A-EL, AW6AX-EL].)

20.  Add ATF to the specified level. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT [AW6A-EL, AW6AX-EL].)

21.  Install the under cover.

22.  Install the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [L3 Turbo].)

23.  Connect the negative battery cable.

24.  Perform the mechanical system test. (See MECHANICAL SYSTEM TEST [AW6A-EL, AW6AX-EL].)