NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION
id011700802000
Required Procedure After Negative Battery Terminal Disconnection/Connection
System name |
Conditions after disconnecting the negative battery terminal |
Required procedure |
Reference |
|
---|---|---|---|---|
Before disconnecting negative battery terminal |
After connecting negative battery terminal |
|||
i-stop system
|
Specified information in the PCM cleared and the i-stop does not operate normally.
|
Verify PID “BATT_SOC” value and record. *1
|
Perform battery condition initial setting (i-stop setting). *2
|
|
Power liftgate (PLG) system
|
—
|
—
|
Fully close the liftgate manually.
|
|
Power window system
|
Reset to initial setting and auto-function is disabled.
|
—
|
Perform the power window system initial setting.
|
|
Position memory system
|
Position memory system memory is reset.
|
Verify the setting content.
|
Set the verified content before disconnecting negative battery terminal.
|
—
|
Clock and audio
|
Clock display and audio system memory are reset.
|
Verify the setting content.
|
Set the verified content before disconnecting negative battery terminal.
|
—
|
Negative Battery Terminal Disconnection
1. Connect the M-MDS to the DLC-2.
2. Switch the ignition ON (engine off).
3. Verify the “BATT_SOC” value using the M-MDS data logger function. (See ON-BOARD DIAGNOSTIC TEST [PCM (SKYACTIV-G 2.5)].)(See ON-BOARD DIAGNOSTIC TEST [PCM (SKYACTIV-D 2.2)].)
4. Record the “BATT_SOC” value.
5. Switch the ignition off.
6. Disconnect the current sensor connector.
7. Disconnect the negative battery terminal.
ac8wzw00003661
|
Negative Battery Terminal Connection
ac8wzw00003662
|
1. Perform battery condition initial setting (i-stop setting). (See BATTERY CONDITION INITIALIZATION SETTING (i-stop SETTING).)
2. Perform services not related to i-stop control which are required after connecting the negative battery terminal. (See Required Procedure After Negative Battery Terminal Disconnection/Connection.)