POWER WINDOW SYSTEM INITIALIZATION PROCEDURE

id091200004100

Note

•  If the following operations have been performed, the initial window setting is reset, and auto up/down operations are disabled. Therefore, reestablishing the initial setting is necessary.

―  Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)

―  Disconnect the power window main switch connector.

―  Remove the power window system power supply fuse.

―  Power window subswitch connector is disconnected.

1.  Switch the ignition ON (engine off or on).

2.  Press each power window main switch or power window subswitch to fully open the door glass.

3.  Pull up and hold each power window main switch or power window subswitch until the door glass is fully closed. Once fully closed, keep holding the switch up at the position for approx. 2 s or more.