REAR WHEEL HUB BOLT REPLACEMENT

id031200800200

Special service tool (SST)

49 T028 3A0   Ball joint puller set

Replacement part

1.  Switch the ignition ON (engine off).

2.  Release the electric parking brake.

3.  Switch the ignition off.

4.  Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)

5.  Remove the wheel and tire. (See WHEEL AND TIRE REMOVAL/INSTALLATION.)

6.  Disconnect the electric parking brake motor gear unit connector. (See ELECTRIC PARKING BRAKE MOTOR GEAR UNIT REMOVAL/INSTALLATION.)

7.  Remove the rear brake caliper component installation bolts.

ac8wzw00002020

8.  Remove the rear brake caliper component and suspend it in a place out of the way using a cable.

ac8wzw00002021

9.  Remove the rear disc plate.

ac8wzw00002022

10.  Remove the rear wheel hub bolt using the SST as shown in the figure.

ac5jjw00003212

11.  Pass the new rear wheel hub bolt through the wheel hub.

12.  Install the rear wheel hub bolt by placing an appropriate-sized washer on the wheel hub and tightening the wheel nut as shown in the figure.

ac8wzw00002023