DTC U0336:00 [DYNAMIC STABILITY CONTROL (DSC)]

id0402b2860900

DTC	U0336:00	Signal error from SAS control module
DETECTION CONDITION		•  Error detected in signal from SAS control module via CAN communication
FAIL-SAFE FUNCTION		Refer to “Fail-safe function table”. (See DTC TABLE [DYNAMIC STABILITY CONTROL (DSC)].)
POSSIBLE CAUSE		•  SAS control module malfunction
SYSTEM WIRING DIAGRAM		Not applicable

Diagnostic Procedure

Step	Inspection		Action
1	VERIFY SAS CONTROL MODULE DTC •  Using the M-MDS, perform the SAS control module DTC inspection. (See DTC INSPECTION [SAS CONTROL MODULE (STANDARD DEPLOYMENT CONTROL SYSTEM)].) (See DTC INSPECTION [SAS CONTROL MODULE (TWO-STEP DEPLOYMENT CONTROL SYSTEM)].) •  Are any DTCs present?	Yes	Go to applicable DTC inspection. (See DTC TABLE [SAS CONTROL MODULE (STANDARD DEPLOYMENT CONTROL SYSTEM)].) (See DTC TABLE [SAS CONTROL MODULE (TWO-STEP DEPLOYMENT CONTROL SYSTEM)].) DTC troubleshooting completed, then go to the next step.
		No	Go to the next step.
2	VERIFY DTC TROUBLESHOOTING COMPLETED •  Using the M-MDS, clear the DTC from the DSC HU/CM. (See CLEARING DTC [DYNAMIC STABILITY CONTROL (DSC)].) •  Using the M-MDS, perform the DSC HU/CM DTC inspection. (See DTC INSPECTION [DYNAMIC STABILITY CONTROL (DSC)].) •  Is the same Pending DTC present?	Yes	Repeat the inspection from Step1 If the malfunction recurs, replace the SAS control module, then go to the next step. (See SAS CONTROL MODULE REMOVAL/INSTALLATION [STANDARD DEPLOYMENT CONTROL SYSTEM].) (See SAS CONTROL MODULE REMOVAL/INSTALLATION [TWO-STEP DEPLOYMENT CONTROL SYSTEM].)
		No	Go to the next step.
3	VERIFY NO DTC IS PRESENT •  Are any DTCs present?	Yes	Go to applicable DTC inspection. (See DTC TABLE [DYNAMIC STABILITY CONTROL (DSC)].)
		No	DTC troubleshooting completed.