ON/OFF SOLENOID REMOVAL/INSTALLATION [GW6A-EL, GW6AX-EL]

id0517i2117100

Replacement part

Bolt

Quantity: 16

Location of use: Oil pan

Oil and chemical type

Silicone sealant

Type: TB1217E or equivalent

Warning

• Do not perform the procedure while the ATF is at a high temperature. Otherwise, it could cause a serious burn.

• Always wear protective eyewear when using an air compressor. If an air compressor is used, dust particles or dirt could spatter and get into the eyes.

1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)

2. Remove front under cover No.2. (See FRONT UNDER COVER No.2 REMOVAL/INSTALLATION.)

3. Clean the outside of the transaxle using steam or degreaser.

4. Drain the ATF. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT [GW6A-EL, GW6AX-EL].)

5. Remove the oil pan.

6. Disconnect the ON/OFF solenoid connector.

Note

• Disconnect the ON/OFF solenoid connector by pressing the connector tab with your fingers.

ac8wzw00001297

7. Remove the ON/OFF solenoid.

ac8wzw00001298

8. Install the ON/OFF solenoid.

ac8wzw00001298

Tightening torque

9—10 N·m {92—101 kgf·cm, 80—88 in·lbf}

9. Connect the ON/OFF solenoid connector.

ac8wzw00001297

10. Apply silicone sealant TB1217E or equivalent to the contact surface of the oil pan.

ac8wzw00001299

Caution

• Clean any remaining silicone sealant on the contact surface of the transaxle case and oil pan, and degrease the sealant area. Otherwise, oil could leak.

11. Install the oil pan using a new bolt before the applied sealant starts to harden.

ac8wzw00001300

Tightening torque

8—10 N·m {82—101 kgf·cm, 71—88 in·lbf}

12. Install front under cover No.2. (See FRONT UNDER COVER No.2 REMOVAL/INSTALLATION.)

13. Add ATF. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT [GW6A-EL, GW6AX-EL].)

14. Connect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)

15. Perform the mechanical system test. (See MECHANICAL SYSTEM TEST [GW6A-EL, GW6AX-EL].)