DTC U0515:68 [INSTRUMENT CLUSTER]
id0902e8988000
|
Description |
Error signal received from start stop unit |
|---|---|
|
Detection condition
|
• The instrument cluster receives error signals from the start stop unit for the ignition switched ON (engine off or on).
|
|
Fail-safe
|
Not applicable
|
|
Possible cause
|
• DTCs are stored in the start stop unit.
• Start stop unit malfunction
• Instrument cluster malfunction
|
|
System wiring diagram
|
Not applicable
|
Diagnostic Procedure
|
Step |
Inspection |
Action |
|
|---|---|---|---|
|
1
|
VERIFY START STOP UNIT DTCs
• Perform the DTC inspection for the start stop unit using the M-MDS.
• Are any DTCs displayed?
|
Yes
|
Repair the malfunctioning part according to the applicable DTC troubleshooting.
(See DTC TABLE [START STOP UNIT].)
|
|
No
|
Go to the next step.
|
||
|
2
|
VERIFY IF MALFUNCTIONING LOCATION IS START STOP UNIT DEPENDING ON REPEATABILITY
• Clear DTC for the instrument cluster using the M-MDS.
• Switch the ignition ON (engine off or on) and wait for 20 s or more.
• Retrieve the DTC inspection for the instrument cluster using the M-MDS.
• Is the same Pending DTC present?
|
Yes
|
Replace the start stop unit, then go to the next step.
|
|
No
|
Go to Step 4.
|
||
|
3
|
VERIFY THAT REPAIRS HAVE BEEN COMPLETED
• Clear DTC for the instrument cluster using the M-MDS.
• Switch the ignition ON (engine off or on) and wait for 20 s or more.
• Retrieve the DTC inspection for the instrument cluster using the M-MDS.
• Is the same Pending DTC present?
|
Yes
|
Replace the instrument cluster, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
4
|
VERIFY IF OTHER DTCs DISPLAYED
• Are any other DTCs displayed?
|
Yes
|
Repair the malfunctioning part according to the applicable DTC troubleshooting.
|
|
No
|
DTC troubleshooting completed.
|
||