FRONT STABILIZER INSTALLATION

id021300803500

1.  After installing the front stabilizer bracket, verify that the positions of the front stabilizer bracket and the front stabilizer bushing are within the range shown in the figure.

adejjw00012514

H1: 5 mm {0.2 in} or less
H2: 5 mm {0.2 in} or less

2.  Temporarily tighten bolts A and B shown in the figure.

ac8wzw00001929

3.  Tighten bolt B.

Tightening torque
25—29 N·m {2.6—2.9 kgf·m, 19—21 ft·lbf}

4.  Tighten bolt A.

Tightening torque
25—29 N·m {2.6—2.9 kgf·m, 19—21 ft·lbf}

5.  Tighten bolt B.

Tightening torque
25—29 N·m {2.6—2.9 kgf·m, 19—21 ft·lbf}

6.  Install the front crossmember component. (See FRONT CROSSMEMBER REMOVAL/INSTALLATION.)

7.  Assemble the intermediate shaft to the steering gear and linkage. (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION.)

8.  Install the joint cover. (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION.)

9.  Assemble the front lower arm ball joint to the steering knuckle. (See FRONT LOWER ARM REMOVAL/INSTALLATION.)

10.  Assemble the outer ball joint to the steering knuckle. (See TIE-ROD END REPLACEMENT.)

11.  Install the following parts.

(1)  Front splash shield (See SPLASH SHIELD REMOVAL/INSTALLATION.)
(2)  Front undercover No.1 (See FRONT UNDER COVER No.1 REMOVAL/INSTALLATION.)
(3)  Front undercover No.2 (See FRONT UNDER COVER No.2 REMOVAL/INSTALLATION.)

12.  Install the front stabilizer control link.

ac8wzw00001930

13.  Install the front ABS wheel-speed sensor and the wiring harness clip as shown in the figure.

ac8wzw00001931

14.  Install the wheels and tires. (See WHEEL AND TIRE REMOVAL/INSTALLATION.)