DTC P0219:00 [MZI-3.7 (PCM CONNECTOR (3 TYPES))]
id0102e4148300
|
DTC P0219:00 |
Engine overspeed condition |
|---|---|
|
DETECTION CONDITION
|
• P0219:00 indicates that the vehicle has been operated in a manner which caused the engine to exceed a calibration limit.
|
|
POSSIBLE CAUSE
|
• Wheel slippage (water, ice, mud and snow).
• Excessive engine rpm in neutral.
|
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
• Has FREEZE FRAME DATA been recorded?
|
Yes
|
Go to the next step.
|
|
No
|
Record FREEZE FRAME DATA on the repair order, then go to the next step.
|
||
|
2
|
VERIFY RELATED SERVICE INFORMATION AVAILABILITY
• Verify related Service Information availability.
• Is any related Service Information available?
|
Yes
|
Perform repair or diagnosis according to the available Service Information.
• If the vehicle is not repaired, go to the next step.
|
|
No
|
Go to the next step.
|
||
|
3
|
INSPECT VEHICLE OPERATION
• Check for:
• Was the vehicle driven under any of the above conditions?
|
Yes
|
Vehicle is normal. Then go to the next step.
|
|
No
|
Clear DTCs and refer to “DIAGNOSTIC INDEX” if customer had any drive ability concerns.
|
||
|
4
|
VERIFY TROUBLESHOOTING OF DTC P0219:00 HAS BEEN COMPLETED
• Verify that all disconnected connectors are reconnected.
• Clear the DTC from the PCM memory using the M-MDS.
• Start the engine and run it at idle.
• Retrieve DTCs using the M-MDS.
• Is the PENDING CODE for this DTC present?
|
Yes
|
Repeat the inspection from Step 1.
• If the malfunction recurs, replace the PCM.
Go to the next step.
|
|
No
|
Go to the next step.
|
||
|
5
|
VERIFY AFTER REPAIR PROCEDURE
• Perform the “AFTER REPAIR PROCEDURE”.
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
|
|
No
|
Troubleshooting completed.
|
||