SPARK PLUG REMOVAL/INSTALLATION [MZI-3.7]


id0118c2800400

Caution
•  If a spark plug that is not as specified is installed, engine performance will be deteriorated. Install only the specified spark plug when replacing.

1.  Disconnect the negative battery cable.

2.  Remove the engine cover. (See ENGINE COVER REMOVAL/INSTALLATION [MZI-3.7].)

3.  Remove the dynamic chamber. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [MZI-3.7].)

4.  Remove the ignition coils. (See IGNITION COIL REMOVAL/INSTALLATION [MZI-3.7].)

5.  Remove the spark plugs using a plug-wrench.

Caution
•  Apply small amount of the specified dielectric grease to the inside of the ignition coils, then install the ignition coils to the spark plugs.
―  Specified grease: Motorcraft XG-3A

6.  Install in the reverse order of removal.

Tightening torque
9—20 N·m {91—204 kgf·cm, 79—177 in·lbf}