BASIC INSPECTION [AW6A-EL, AW6AX-EL]

id050310800300

STEP

INSPECTION

ACTION
1
•  Measure the battery voltage.
•  Is the battery voltage 10.0—14.0 V?
Yes
Go to the next step.
No
Replace or recharge the battery.
(See BATTERY RECHARGING [MZI-3.7].)
2
•  Inspect the TCM related harnesses, connectors and fuses.
•  Are they normal?
Yes
Go to the next step.
No
Repair or replace any malfunctioning parts according to the inspection result.
3
•  Warm up the engine to normal operating temperature.
•  Retrieve DTC using the M-MDS.
•  Is there any DTC present?
Yes
Record Freeze Frame Data and perform appropriate DTC troubleshooting procedures.
No
Go to the next step.
4
•  Perform the road test.
•  Is the ATX operating normally?
Yes
Go to the next step.
No
Repair or replace any malfunctioning parts according to the inspection result.
5
•  Perform the time lag test.
•  Is the ATX operating normally?
Yes
Go to the next step.
No
Repair or replace any malfunctioning parts according to the inspection result.
6
•  Perform the stall test.
•  Is the stall speed within the specified?
Yes
Go to the next step.
No
Repair or replace any malfunctioning parts according to the inspection result.
7
•  Perform the line pressure test.
•  Is the line pressure within the specified?
Yes
Perform the symptom troubleshooting and follow the procedures.
No
Repair or replace any malfunctioning parts according to the inspection result.
8
•  Inspect following part or signal related PIDs using the M-MDS.
PCM PIDs:
―  APP sensor (APP1, APP2)
―  Brake switch (BOO)
―  Engine speed (RPM)
TCM PIDs:
―  TSS (TSS)
―  VSS (VSS)
―  TFT sensor (TFT, TFTV)
―  TR switch (TR)
―  M range switch (MNL SW)
―  Up switch (UP SW)
―  Down switch (DWN SW)
•  Are they normal?
Yes
Perform the symptom troubleshooting and follow the procedures.
No
Repair or replace any malfunctioning parts according to the inspection result.