NO.9 NO AUDIO SYSTEM ILLUMINATION [ENTIRE AUDIO SYSTEM]
id0903e2826600
|
9 |
No audio system illumination |
||
|---|---|---|---|
|
Possible DTC |
Using the M-MDS |
U3003:16 |
|
|
Without using M-MDS (On-board diagnostic test mode) |
Audio unit (without display) |
09:Er20, 21:Er19 |
|
|
Audio unit (with display) |
• Device code 09/error code 20
• Device code 21/error code 19
|
||
|
Car-navigation unit |
• Device code 09/error code 20
• Device code 21/error code 19
|
||
|
Possible cause
|
• Burnt fuse (TNS signal)
• Open or short circuit in TNS signal wiring harness
• Poor connection of audio unit/car-navigation unit connector, terminal damage
• Audio unit/car-navigation unit malfunction
|
||
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
• Are all illumination on the audio unit/car-navigation unit turned OFF?
|
Yes
|
Go to the next step.
|
|
No
|
Audio unit
• Replace the audio panel.
car-navigation unit
• Replace the car-navigation unit.
|
||
|
2
|
• Turn the ignition switch to the LOCK position.
• Inspect the fuse (ILLUMI).
• Is the fuse normal?
|
Yes
|
Go to Step 4.
|
|
No
|
Go to the next step.
|
||
|
3
|
• Disconnect the audio unit connector (24-pin) and inspect the continuity between the audio unit/car-navigation unit wiring harness-side connector terminal 1E (TNS) and the ground.
• Is there continuity?
|
Yes
|
Repair or replace the short circuit in the suspect wiring harness. After repair the harness, replace with the appropriate standard fuse.
|
|
No
|
Go to the next step.
|
||
|
4
|
• Inspect the connection of the audio unit/car-navigation unit connector (24-pin).
• Inspect both the audio unit/car-navigation unit and wiring harness-side connector terminal 1E for poor connection (such as damaged/pulled-out pins, corrosion).
• Are all the pins normal?
|
Yes
|
Go to the next step.
|
|
No
|
If poor connection of audio unit/car-navigation unit connector:
• Securely connect the audio unit/car-navigation unit connector.
If the audio unit/car-navigation unit side connector is wrong:
• Replace the audio unit/car-navigation unit.
If the wiring harness-side connector is wrong:
• Repair or replace the pins and/or the connector.
|
||
|
5
|
• Connect the audio unit/car-navigation unit connector (24-pin).
• Turn the ignition switch to the ACC position.
• Inspect the voltage at the audio unit/car-navigation unit connector terminal 1E (TNS).
• Is the voltage B+ when the light switch is turned to the TNS position?
|
Yes
|
Replace the audio unit/car-navigation unit.
|
|
No
|
Repair or replace the suspect wiring harness (TNS signal).
|
||