FRONT SEAT CUSHION TRIM REMOVAL/INSTALLATION

id091300487800

Warning

•  Handling the front seats improperly can accidentally deploy the side air bag, which may seriously injure you. Read air bag system service warnings and cautions before handling the front seats. (See AIR BAG SYSTEM SERVICE WARNINGS) (See AIR BAG SYSTEM SERVICE CAUTIONS)

Caution

•  After removing a front seat, do not operate the slider lever. If the slider lever is operated, the left and right slide positions will deviate, and the slide adjuster may be damaged after the front seat is installed.

•  Verify that there are no malfunctions in the sliding mechanism after installing a front seat.

•  When performing the procedure with a front seat removed from the vehicle, perform the procedure on a clean rag so as not to damage or soil the seat.

1.  Switch the ignition to off.

2.  Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [MZI-3.7].)

3.  Disconnect the negative battery cable and wait 1 min or more.

4.  Remove the following parts:

(1)  Front seat (See FRONT SEAT REMOVAL/INSTALLATION.)

(2)  Front seat side cover (See FRONT SEAT SIDE COVER REMOVAL/INSTALLATION.)

(3)  Front seat front cover (See FRONT SEAT FRONT COVER REMOVAL/INSTALLATION.)

5.  Cut the band securing the seat warmer module (Vehicles with seat warmer), side air bag and lumber support (Vehicles with power lumber support) wiring harness.

6.  Disconnect the seat warmer (Vehicles with seat warmer), side air bag and lumber support (Vehicles with power lumber support) connector.

7.  Remove the nuts (Power seat, Driver-side manual seat), remove the screw (Passenger-side manual seat) remove the seat under bracket and the seat under bracket cover.

ac9wzw00001283

ac9wzw00001284

8.  Remove the bolts then remove the front seat cushion component.

ac9wzw00002476

9.  Detach hook A.(Driver-side only)

acxuuw00004065

10.  Detach hook B and C in the direction of the arrow shown in the figure.

acxuuw00004066

11.  Detach hook D in the direction of the arrow shown in the figure then remove the front seat cushion trim and front seat cushion pad as a single unit from the front seat cushion frame.

ac9wzw00001285

12.  Remove rings C in the order of (1), (2), and (3) as shown in the figure, then remove the seat cushion trim from the seat cushion pad in the direction of the arrow shown in the figure.

ac9wzw00001286

13.  Install in the reverse order of removal.