DTC P0602 [MZI-3.7]
id0102d2809200
|
DTC P0602 |
PCM programming error |
|---|---|
|
DETECTION CONDITION
|
• This DTC indicates a programming error within the vehicle ID block.
|
|
POSSIBLE CAUSE
|
• Vehicle ID data corrupted by the M-MDS during vehicle ID reprogramming
|
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
• Has FREEZE FRAME DATA been recorded?
|
Yes
|
Go to the next step.
|
|
No
|
Record FREEZE FRAME DATA on the repair order, then go to the next step.
|
||
|
2
|
VERIFY RELATED SERVICE INFORMATION AVAILABILITY
• Verify related Service Information availability.
• Is any related Service Information available?
|
Yes
|
Perform repair or diagnosis according to the available Service Information.
• If the vehicle is not repaired, go to the next step.
|
|
No
|
Go to the next step.
|
||
|
3
|
VERIFY TROUBLESHOOTING OF DTC P0602 HAS BEEN COMPLETED
• Verify that all disconnected connectors are reconnected.
• Turn the ignition switch to the ON position (Engine off).
• Clear the DTC from the PCM memory using the M-MDS.
• Perform the “KOEO and KOER self-test”.
• Retrieve DTCs using the M-MDS.
• Is the PENDING CODE for this DTC present?
|
Yes
|
Replace the PCM, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
4
|
VERIFY AFTER REPAIR PROCEDURE
• Perform the “After Repair Procedure”.
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
(See DTC TABLE [MZI-3.7].)
|
|
No
|
Troubleshooting completed.
|
||