POSITIVE CRANKCASE VENTILATION (PCV) VALVE INSPECTION [MZI-3.7]


id0116d2800400

Note
•  The PCV valve cannot be reassembled once it is removed because the tabs will have been broken. Inspect the PCV valve without removing it from the vehicle.

Airflow Inspection

1.  Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [MZI-3.7].)

2.  Disconnect the PCV valve hose from the PCV valve. (See POSITIVE CRANKCASE VENTILATION (PCV) VALVE REMOVAL/INSTALLATION [MZI-3.7].)

3.  Verify that there is no airflow when pressure is applied to the PCV valve using a vacuum pump.

•  If there is airflow, replace the PCV valve. (See POSITIVE CRANKCASE VENTILATION (PCV) VALVE REMOVAL/INSTALLATION [MZI-3.7].)

4.  Verify that there is airflow when vacuum is applied to the PCV valve.

•  If there is no airflow, replace the PCV valve. (See POSITIVE CRANKCASE VENTILATION (PCV) VALVE REMOVAL/INSTALLATION [MZI-3.7].)


Resistance Inspection (With PCV valve heater)

1.  Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [MZI-3.7].)

2.  Remove the engine cover. (See ENGINE COVER REMOVAL/INSTALLATION [MZI-3.7].)

3.  Disconnect the PCV valve heater control connector.

4.  Measure the resistance between the PCV valve heater control terminals.

•  If not within the specification, replace the PCV valve. (See POSITIVE CRANKCASE VENTILATION (PCV) VALVE REMOVAL/INSTALLATION [MZI-3.7].)
PCV valve heater control resistance
10—35 ohms
ac9uuw00000584