CAMSHAFT POSITION (CMP) SENSOR INSPECTION [MZI-3.7]

id0140c3801400

Visual Inspection

1.  Remove the CMP sensor. (See CAMSHAFT POSITION (CMP) SENSOR REMOVAL/INSTALLATION [MZI-3.7].)

2.  Verify that there are no metal shavings on the CMP sensor.

•  If there is a malfunction, replace the CMP sensor. (See CAMSHAFT POSITION (CMP) SENSOR REMOVAL/INSTALLATION [MZI-3.7].)

3.  Install the CMP sensor. (See CAMSHAFT POSITION (CMP) SENSOR REMOVAL/INSTALLATION [MZI-3.7].)

Resistance Inspection

1.  Remove the CMP sensor connector.

2.  Measure the resistance between the CMP sensor terminals.

•  If not within the specification, replace the CMP sensor. (See CAMSHAFT POSITION (CMP) SENSOR REMOVAL/INSTALLATION [MZI-3.7].)