REAR HEATED OXYGEN SENSOR (HO2S) INSPECTION [MZI-3.7]

id0140c3804900

Sensor Output Value Inspection (Rear HO2S)

1.  Warm up the engine to normal operating temperature.

2.  Using the M-MDS, monitor the following: (See ON-BOARD DIAGNOSTIC TEST [MZI-3.7].)

―  Vehicle speed (PID: VSS)

―  Engine speed (PID: RPM)

―  Rear HO2S voltage (PID: O2S12, O2S22)

3.  Drive the vehicle and decelerate the engine speed by releasing the accelerator pedal fully when the engine speed is 3,000 rpm or more.

4.  Verify that the rear HO2S outputs a voltage of 0.6 V or more, one time or more, then verify that the rear HO2S voltage (PID: O2S12, O2S22) is 0.3 V is or less while decelerating as shown in the figure.

atraaw00003394

•  If not within the specification, replace the rear HO2S. (See REAR HEATED OXYGEN SENSOR (HO2S) REMOVAL/INSTALLATION [MZI-3.7].)

Resistance Inspection (Rear HO2S Heater)

1.  Disconnect the rear HO2S connector.

2.  Measure the resistance between rear HO2S terminals C and A.

ac9wzw00000111

•  If it is not within the specification, replace the rear HO2S. (See REAR HEATED OXYGEN SENSOR (HO2S) REMOVAL/INSTALLATION [MZI-3.7].)