DTC P0706 [AW6AX-EL]
id0502j6800900
|
DTC P0706 |
Transaxle range (TR) switch circuit range/performance |
|---|---|
|
DETECTION CONDITION
|
• TCM detects stuck TR switch when ignition switch is at ON position.
Diagnostic support note:
• This is continuous monitor (CCM).
• The MIL illuminates if the TCM detects the above malfunction condition during first drive cycle.
• A PENDING CODE is not available.
• FREEZE FRAME DATA is available.
• The AT warning light illuminates.
• The DTC is stored in the TCM memory.
|
|
POSSIBLE CAUSE
|
• TR switch malfunction
• TCM malfunction
|
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
• Has the FREEZE FRAME DATA been recorded?
|
Yes
|
Go to the next step.
|
|
No
|
Record the FREEZE FRAME DATA on the repair order, then go to the next step.
|
||
|
2
|
VERIFY RELATED REPAIR INFORMATION AVAILABILITY
• Verify related Service Information availability.
• Is any related repair information available?
|
Yes
|
Perform repair or diagnosis according to the available repair information.
• If the vehicle is not repaired, go to the next step.
|
|
No
|
Replace the TCM, then go to the next step.
|
||
|
3
|
VERIFY TROUBLESHOOTING OF DTC P0706 COMPLETED
• Make sure to reconnect all the disconnected connectors.
• Clear the DTC from the memory using the M-MDS.
• Drive the vehicle in each range (P—D).
• Is the same DTC present?
|
Yes
|
Replace the TCM, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
4
|
VERIFY AFTER REPAIR PROCEDURE
• Perform the “After Repair Procedure”.
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
(See DTC TABLE [AW6AX-EL].)
|
|
No
|
DTC troubleshooting completed.
|
||