POWER WINDOW SUBSWITCH INSPECTION


id091200802200


Passenger Side

1.  Measure the voltage at each terminal (other than terminals I).

•  If the voltage is not as specified in the Terminal Voltage Table, inspect the parts under “Inspection item(s)” and related wiring harnesses.

2.  Disconnect the negative battery cable.

3.  If the system does not work properly even though the inspection items or related wiring harnesses do not have any malfunction, replace the power window subswitch.

ac9uuw00002423

Terminal

Signal name

Connected to

Measured condition

Voltage (V)/Continuity

Inspection item (s)

A
Communication
Power window main switch
Because this terminal is for communication, good/no good judgment by terminal voltage is not possible.
•  Power window motor (SeePOWER WINDOW MAIN SWITCH INSPECTION.)
•  Related wiring harnesses
B
Power supply
Power window motor
Ignition switch at ON or during IG-OFF timer
B+
•  Power window motor (SeePOWER WINDOW MOTOR INSPECTION.)
•  Related wiring harnesses
C
Close output
Power window motor
While door glass is opening
1.0 or less
•  Power window motor (SeePOWER WINDOW MOTOR INSPECTION.)
•  Related wiring harnesses
While door glass is closing
B+
D
Sensor ground
Power window motor
Under any condition
1.0 or less
•  Power window motor (SeePOWER WINDOW MOTOR INSPECTION.)
•  Related wiring harnesses
E
GND
Body ground
Under any condition
1.0 or less
•  Related wiring harnesses
G
Pulse 2
Power window motor
Door glass moving
Alternates between 1.0 or less and 5.0
•  Power window motor (SeePOWER WINDOW MOTOR INSPECTION.)
•  Related wiring harnesses
Door glass stopped
1.0 or less or 5.0
I
Power supply
P/W 30 A fuse
Under any condition
B+
•  P/W 30 A fuse
•  Related wiring harnesses
J
Pulse 1
Power window motor
Door glass moving
Alternates between 1.0 and 5.0
•  Power window motor (SeePOWER WINDOW MOTOR INSPECTION.)
•  Related wiring harnesses
Door glass stopped
1.0 or less or 5.0
K
Open output
Power window motor
While door glass is opening
B+
•  Power window motor (SeePOWER WINDOW MOTOR INSPECTION.)
•  Related wiring harnesses
While door glass is closing
1.0 or less
L
Power-cut signal
Power window main switch
Ignition switch at ON and power-cut switch at UNLOCK
B+
•  Power window main switch(SeePOWER WINDOW MAIN SWITCH INSPECTION)
•  Related wiring harnesses


Rear Side

1.  Inspect for continuity between the power window subswitch terminals.

•  If not as specified, replace the power window subswitch.
ac9uuw00000475
acxuuw00001389