THROTTLE POSITION (TP) SENSOR INSPECTION [MZI-3.7]

id0140c3802700

Note

•  The TP sensor cannot be removed as a single unit. When replacing the TP sensor, replace it together with the throttle body as a single unit.

Voltage Inspection

1.  Verify that no DTC related to APP sensor has been detected. (See ON-BOARD DIAGNOSTIC TEST [MZI-3.7].)

•  If any DTCs related to APP sensor have been detected, perform the DTC inspection. (See DTC TABLE [MZI-3.7].)

2.  Connect the M-MDS to the DLC-2.

3.  Turn the ignition switch to the ON position.

4.  Operate the accelerator pedal and verify that the TP sensor output voltage (PID: TP1, TP2) changes as shown in the following graph. (See ON-BOARD DIAGNOSTIC TEST [MZI-3.7].)

ac9wzw00001741

•  If it cannot be verified, replace the throttle body. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [MZI-3.7].)